I put a 65MM focus central thottle body on my zx2 and need a 90 degree coupler for it. I have 2.5" charge pipes and need the right size coupler. I suppos i need a 3"-2.5" 90* elbow, correct? Will a 3"-3" 90* work??

charge pipes? your z boosted?

as for the coupler, 3" should work but a 3"-2.5" will be fine

intake pipe

could be boosted but not by means of that info

lol well after reading another post, he is going turbo... so i stand corrected

he isn't turbo'd shaun has been working on a turbo set up for awhile...but he doesn't have it installed

Actually, my zx2 is my project car, I parked her to install lots of goods including .400 cams. I HAVE the charge pipes ran, BOV welded and monted, 65mm TB mounted. All I have to do to start my care right now is figure out what imma do about my turbo mannifold. I have an OBX focus header, but I dont know if someone can make my External wastegate mount. So, I mabey looking for a Log mannifold, so its more convient for me to mount the turbo and externalewastgate and be done.

So anyone know where I can get a bolt up turbo mannifold, share please. I may be willing to sell/TRADE this OBX header, its in damn good shape.

run stock cams with turbo, lose the 400 cams..or you'll regret it later...

ill find that out on the dyno, thank you for the heads up though!, right now i need to worrie about getting a turbo header!!!

hmm turbo header, dunno who would have one of those

and why are those cams bad jarred? i was planning on running either high rev or high torque cams in my built engine...

another argument with Vit........