help decide, its alot smaller then I had orginally wanted to find, but for the price and the output it doesn't seem to bad.

its bb
rated for up to 330 (which will take me a shitload to get to anyways)

fast spool cause its small.

what do you all think?

http://cgi.ebay.com/ebaymotors/ws/eBayISAP...em=150113661822

I'd say def not bad for the price!

Could work but what rpm range are you looking for full spool? I think it might be a bit laggier than you're thinking. It would work though.

since the zetec makes enough low end torq, I wouldn't need boost til around 3500 rpms, pulling to 7k

270 is what its rated for, 330 is a typo. His reponses to my emails have been prompt. Think I'm going to go for it. Since I probally wont be anywhere near 230+ whp since that requires a built motor, this seems fine to me. Time I get a built motor, i can upgrade the turbo then.

oh and if I can find a t04s compressor and housing that will make it a gt2540r which is rated around 350-400 , I'll just need the parts and a new balance.

got a gt2871r coming, should be here tomorrow, going to prep it, the header downpipe and get it all coated within the next few weeks. Gotta get some welding done on it, so gotta work that out with my buddy old pal paul

http://kctuners.org/forum/uploads/11695223..._2_51_33739.jpg
http://kctuners.org/forum/uploads/11695223..._2_51_19299.jpg

getting ready to get the header, turbo exhaust housing and the downpipe coated w/ 2000 degree, also might get the compressor side polished up intake and outside of it.

3inch intake, 2 inch output on the turbo.