Pioneer head 50x4 watt max
Infinity Ref 6 1/2
Infinity Ref 6x8
Hifonics BX605 300watt rms at 2ohm
Audiobahn 8gauge install kit
Infinity 1232 wired for 2ohm load rms rating of 300 watt 1200 max
Sealed box with 1.25 cu.ft sub needed sealed 1.25

Oh sound quality is beautiful and can be quite loud if I turn up the bass boost. As it is now its only a 1/4 turn up from 0. At full it makes my mirror dance a jig.

This system was made for itself. Perfect in all ways. Sound quality, loudness, crispness, low end, high end.

Listened to Gorillaz new cd on the way to work B)

wow, nice setups, have fun with it and stay away from dick cops that will follow you to work and then harass you for being too loud :lol:

Nah the beauties of sound deadening are coming very very soon

8) that is going to be such a nice road trip.

Make sure you swap a sedan transaxle in there before you leave. Make it here on 1 tank of gas, heh.

here? CJW are you stopping by KC??? but ya, forgot about the road trip for a minute, should have a lot of fun with that setup on the open road

Nah I dont know what Insta is talking about we are going to florida

Shut up you bastard!!!

Anyway yes it will be a nice road trip and no I know for a fact I will not make it to where I am going on one tank of gas. Id like a sedan tranny but the pile of crap to be installed is already way too long for me to schedule in finding a tranny.

And Bryan since you spilled the beans I am posting about it. PDT_Armataz_01_02

Ouch burn. Way to open your mouth chief... lol. :D

Nah its cool. Bryan didnt know.

Anyway its good timing cuz we JUST picked a date.

:lol:

Anyway system at 15 will wake the neighbors for blocks... 8)

Makes me miss mine, cerwin vega 6 1/2 components, 6x8s, and 12 inch subs with rockford fosgate amps, cap, and wires, with punch bass control. Especially since my whole interior is covered in dynamat extreme. Sadly the amps and cap were stolen and have yet to be replaced, but on the plus side the sub box was too big to get out through the back seat lol. I don't think I'm gonna replace all of it just need a small amp to power the mids and highs again think I'll leave to box out. Can't wait to see your setup though sounds sweet.

you could have always deleted my post :P

yes but you still wouldve known. No biggie.

Ya I am going to be edead'ing the entire thing and dual layering it over the exhaust channel.

Also, I am changing out the head for something a little more long trip oriented :twisted:

and possibly a parts car with power doors and such so I can have them as well 8)