I want the below things installed by Jan 1st.
1) Intake Manifold (PnP'd later)
2) 98 Valve Cover
3) Hotshot Intake
4) GT rear disc swap
5) POTS setup
6) Shift Kit
=============
These things can wait a bit:
7) 65mm Focus TB (PnP'd later)
8) Zetec Head (PnP'd later)

Thats about it for now, im sure i will think of more things i am looking for later. So keep an eye out for great deals on these things. I am sure i can get good deals from Bryan and i will go to him regardless for the parts and install for the disc, pots and shiftkit.

Everything sounds good except for the hotshot intake and the pots..... opinion

hotshot intake is ok for a stock car. If you ever plan to have a lot of horsepower...going past that of bolt ons...it is not a good intake. I dont care what anybody says on the topic 2.5" is too small. your MAF opening is 2.75" your TB is 2.75" Id say on a high hp at least 2.75" if not 3"

65mm focus unit is cut from a hunk of billet. Its not stock so there is no need to p-n-p it later

But good luck on your buys. I know where you can get everything new except the head and intake mani.

jerk! lol, i am bound to make this atx faster than most mtx's! the X2 will greatly improve it and i cant wait for it.

as for the intake CJ, ya we talked about this before but i dont plan on going high HP anytime soon, i hope to have all the bolt on stuff done by spring...